Home > News > News

13 Tips For Seeder Maintenance(1)

Feb. 07, 2021

13 Tips For Seeder Maintenance(1)

Seeder Suppliers will share this article with you.
Considering that you don't need to fret about changing worn plow shins and also shares, sculpt points or disk bearings, it is important to put some additional time into seeder maintenance. Winter season is a good time to do that to make sure that come spring you don't have any kind of worries or breakdowns. Bear in mind that each hour lost in springtime due to seeder issues are extremely expensive due to delayed planting.
In addition, concerns with return decreases in no-till can usually be traced back to failure to assure exact seed placement. It is all as well typical to see irregular seed deepness, seeds at the soil surface, open seed slots, compacted soil in addition to the seeds, hairpinning, sidewall compaction, increases as well as triples, etc. So seeder efficiency becomes vital. It is specifically crucial in no-till because of high infiltration resistance, and cover plants or plant residue at the soil surface area.
1. Meters
Metering devices need to function well or you'll obtain frequent skips, doubles and also triples. To assure optimal performance, take metering systems apart every winter season.
Get rid of dirt and clean the hood with soapy water (no kerosene, diesel or oil must ever before be utilized in meter systems). Change cracked plastic covers. Replace busted fingers in a finger-pickup meter. Seed brushes need to be replaced when put on. If a groove has formed in the chromium residence of the metering unit it is time to change it.
The belt (in finger pick-up meters) need to be flexible, not have splits in it, as well as need to be tidy. Clean with soapy water and let it completely dry before putting it back in. When placing the metering system back with each other, the rubber belt need to be put in the right direction, or your meter will malfunction. You can lubricate with graphite.
It is advised to take your finger pick-up metering unit to a dealer to have it calibrated each year or every 300-400 acres. Take a bag of your very own seed with you, as well as offer the correct rate at which you'll be driving.
If you have a vacuum or air meter, look for leakages and also appropriate vacuum or atmospheric pressure.
2. Seeder system
Accurate deepness placement can be compromised if seeder devices are loose or unsteady. You should not be able to quickly lift up your unit or move it laterally. Look across your seeder systems from the side. Are they all at the same elevation? If one system is either up or down compared to the others, it needs job. An usual trouble is that some screws are loose or additional bushings are needed. You likewise require to replace split or broken seed hoppers.

seeder

Previous: 13 Tips For Seeder Maintenance(2)

Next: What to Take into consideration When You Get a Fertilizer Spreader

+86 186 0326 0506 shichangbu@china-zyjd.com 1561238442